Adjustable vertical knee of the cable ladder The adjustable downward vertical knee of the cable ladder or CABLE LADDER INSIDE RISER is used in places of the cabling path where there is a level difference between the cabling path and the cables are guided to the desired level by the ascending or descending knees. The..

Turn right into the cable ladder Converting to the right of the cable ladder or RIGHT REDUCER FOR CABLE LADDER is used in places where the volume of cables is reduced (reducing conversion) or the volume of cables is increased (increasing conversion). It can also be used to reduce or increase the conversion. to the..

Turn left cable ladder LEFT REDUCER FOR CABLE LADDER is used in places where the volume of cables decreases (decrease conversion) or the volume of cables increases (increase conversion). It can also be used to reduce or increase conversion. to the right, left or middle. The width of the conversion starts from 100 mm and..

Intermediary cable ladder joint JOINT is one of the side accessories of the cable ladder, which is used to connect the two branches of the cable ladder to each other and in pairs on both sides of the ladder. It is made and used in two models, short wall and long wall. Joint floor 30..

CABLE LADDER CROSS is used in places of the cable laying route where the cables meet at one point from four directions and a crossroads is created. It is made in hot plating mode (for wet areas) and cold plating, and there are two types It has four bends or six bends. The width of..

CABLE LADDER TEE is used in places of the cable laying route where the cables meet in one point from three directions and a three-way mode is created. It is made in hot plating mode (for wet areas) and cold It has two types, four bends or six bends. The width of each opening of..

90 degree elbow of cable ladder CABLE LADDER BEND 90 is used in places where the cable route changes at a 90 degree angle. It is made in two hot and cold plating modes (in wet areas) and has four bends or six bends. The knee is used according to the customer’s order and based..

45 degree cable tray bend or CABLE TRAY BEND 45 is used in places of the cable route where the cable route is changed at an angle of 45 degrees. It is made in two modes of hot plating (in wet areas) and cold (galvanized fabric) and Four bends or six bends are used according..