90 degree elbow of cable ladder

90 degree elbow of cable ladder

CABLE LADDER BEND 90 is used in places where the cable route changes at a 90 degree angle. It is made in two hot and cold plating modes (in wet areas) and has four bends or six bends. The knee is used according to the customer’s order and based on the type of cable ladder. The type of connection of the ladder to the body can be either welded or bolted. The width of each knee opening is from 100 mm to 1000 mm, and the wall height is from 20 mm to 250 mm, and the thickness of the sheet used for hot plating is from

1.25 to 2 and for galvanizing fabric from 0.6 to 2.

	H(mm)	T(mm)
1000~100	250~20	2~0.6

Tags :

Cancel reply

droversointeru Saturday,2025,05

Hello, Neat post. There’s an issue along with your website in internet explorer, may check thisK IE nonetheless is the marketplace chief and a large component of other folks will miss your excellent writing due to this problem.

Reply

Adina Shipps Tuesday,2025,04

This is very attention-grabbing, You are an excessively professional blogger. I have joined your rss feed and look forward to in quest of more of your wonderful post. Also, I have shared your web site in my social networks!

Reply

tlovertonet Wednesday,2025,04

Hi my friend! I want to say that this article is awesome, nice written and include approximately all vital infos. I?¦d like to look extra posts like this .

Reply